The use and maintenance of the engine MAZDA Brazed Radiator
When start a car, the heat generated by the engine enough to destroy the car itself, so to install a set of cooling system to protect it from damage, and make the engine in the appropriate temperature range, while keep the engine from burned can also a steady stream of power. MAZDA Brazed Radiator is the main part of the cooling system, its principle is to use cold air to reduce the MAZDA Brazed Radiator inside come from the engine coolant temperature, so as to achieve the purpose of cooling the engine. Therefore, the MAZDA Brazed Radiator is also an important part of the engine. It should pay attention to the following points in the process of use:
1. MAZDA Brazed Radiator should not be in contact with any acid, alkali or other corrosive liquid to prevent corrosion damage;
2. Suggest using soft water for coolant. The hard water needs to be softened (ion exchange or boiling) to be used after treatment, so as to avoid the buildup of water scale in the MAZDA Brazed Radiator;
3. In order to avoid the corrosion of MAZDA Brazed Radiators in the use of antifreeze liquid, it is important to use regular manufacturers to produce and meet the national standard long-acting anti-rust anti-freeze solution;
4. During the installation of MAZDA Brazed Radiators, be careful not to damage the scattered tropical (film) and the damaged MAZDA Brazed Radiator to ensure heat dissipation capacity and seal;
5, MAZDA Brazed Radiator again completely put water in the water injection, on the water to the engine cylinder body of the switch is turned on, to have the water out, and then closed, so as to avoid blisters, heat;
6. The water level should be checked at any time in daily use, and the water should be added after cooling down. When adding water, the water tank should be opened slowly, and the staff should try to stay away from the water inlet to prevent the high-pressure steam from spewing from the nozzle.
7. In the winter, to prevent the freezing of the MAZDA Brazed Radiator core, such as in long term parking or indirect parking, the water tank cover and water discharge switch should be opened, and all water will be released;
8. The surface of the MAZDA Brazed Radiator should be completely cleaned after 1 ~ 3 months. When cleaning, flush the side of the counterwind with clear water. Regular full cleaning prevents the MAZDA Brazed Radiator core from being blocked by dirt and affects heat dissipation.
9. Water level meter should be cleaned every 3 to 6 months or depending on the actual situation to remove the components with warm water and non-corrosive detergent;
Proper injection of coolant
1. Don't worry too much when adding the coolant, otherwise, the gas in the engine cylinder is not easy to discharge, which can cause the engine to be too hot in operation;
2. After adding the coolant, the engine should be stopped and checked again until the engine is full.
The MAZDA Brazed Radiator is located in the outside of the vehicle grille and can be seen without even opening the grille, which can be directly exposed to the outside. So the dirt coming from the grille is easy to attach to the mesh MAZDA Brazed Radiator. Especially in the spring and autumn season, some floccules and leaves and other sundries float in the air, easy to get into the grille and attach to the MAZDA Brazed Radiator. Besides some mud, dust, floats in the air also can be in driving crashed into the MAZDA Brazed Radiator, at the same time, some of the floating in the water road dirt into the summer will also enter the MAZDA Brazed Radiator when driving, not timely cleaning will block the ventilation holes, reduce the heat dissipation effect, cause air conditioning is not cold water temperature rise higher, so it's very important to timely cleaning MAZDA Brazed Radiator.
