MAZDA Brazed Radiator how to better maintenance
MAZDA Brazed Radiator and the wall distance should not be less than 30mm, and the distance from the ground should be 200-300mm is appropriate to install the connection pipe inlet and outlet axis and MAZDA brazed radiator inlet and outlet center should be consistent, otherwise Will cause installation difficulties and damage the MAZDA brazed radiator. Install the joints, plugs and run the wind when the thread must be evenly coated with lead oil, and then a small amount of hemp thread winding, hand on the buckle, confirm the buckle and then use the tools to tighten, remember not to force too much to avoid Damage, after installation, to check the overall installation and pressure testing, MAZDA Brazed Radiator itself and the threaded connection shall not have any leakage, do not meet the installation requirements to be adjusted or re-assembly. MAZDA Brazed Radiator should not be removed before the installation is completed, or other decoration works of the same project should not be removed MAZDA Brazed Radiator packaging, so as not to MAZDA brazed radiator surface damage.
Heating MAZDA Brazed Radiator improper maintenance, affecting the cooling effect, but also affect the MAZDA Brazed Radiator life. The following experts for us to talk about the common MAZDA Brazed Radiator maintenance errors, mainly from 9 aspects:
1, during the heating, MAZDA Brazed Radiator internal air may be, will affect the cooling effect, should be timely discharge, hand or special tools to turn the running knob, so that MAZDA Brazed Radiator internal air emptied until You can tighten the knob when there is water outflow.
2, MAZDA Brazed Radiator heating system water quality must meet the national standard of use (PH value control between 7-9 is appropriate).
3, MAZDA Brazed Radiator operation should be scheduled according to the standard working pressure (usually 4-6Mpa).
4, during heating or non-heating season MAZDA Brazed Radiator must not be water and water, must be full of water maintenance.
5, MAZDA Brazed Radiator inside the water must not have icing phenomenon, or lead to MAZDA brazed radiator deformation, frozen until damaged.
6, is strictly prohibited the use of industrial waste water, high pressure steam and slightly acidic, slightly alkaline solution as a heat source for heating.
7, the boiler must be turned off before cleaning the total pipeline valve to prevent the acid into the pipeline and MAZDA Brazed Radiator, resulting in pipeline and MAZDA Brazed Radiator system corrosion.
8, MAZDA Brazed Radiator in the daily cleaning with a wet cloth or brush cleaning, is strictly prohibited with the corrosion of solvents and solutions to wash, so as not to damage the MAZDA brazed radiator surface.
9, the use of the process should prevent other objects impact or scratch MAZDA Brazed Radiator, such as the emergence of local small area of the skin, shedding and scratches should be promptly with the same color paint to repair, so as to avoid large area damage.
